The following is a list of all the commands required to complete Assignment 1. If your results are different than the sample drawing file, check your input against these. Press the F2 key to see your input. (Press F2 to close the text screen).

Command: line <enter>
Specify first point: 1,2 <enter>

Specify next point or [Undo]: 3,2 <enter>

Specify next point or [Undo]: 3,4 <enter>

Specify next point or [Close/Undo]: 1,4 <enter>

Specify next point or [Close/Undo]: c <enter>
(Completes the first box)

Command: l <enter>
LINE Specify first point: 4.5,2 <enter>

Specify next point or [Undo]: @2,0 <enter>

Specify next point or [Undo]: @0,2 <enter>

Specify next point or [Close/Undo]: @-2,0 <enter>

Specify next point or [Close/Undo]: @0,-2 <enter>

Specify next point or [Close/Undo]: <enter>
Completes the second box

Command: l
LINE Specify first point: 8,2

Specify next point or [Undo]: @1<45

Specify next point or [Undo]: @1<135

Specify next point or [Close/Undo]: @1<225

Specify next point or [Close/Undo]: @1<315

Specify next point or [Close/Undo]:
Completes the 3rd, angled box

Command: c
CIRCLE Specify center point for circle or [3P/2P/Ttr (tan tan radius)]: 7,6

Specify radius of circle or [Diameter]: .75
Completes the circle

Command: l
LINE Specify first point: 0,0

Specify next point or [Undo]: @10,0

Specify next point or [Undo]: @0,7

Specify next point or [Close/Undo]: @-10,0

Specify next point or [Close/Undo]: c
Completes the border

Command: save

Command: plot