The following is a list of all the commands required to complete Assignment 3. If your results are different than the sample drawing file, check your input against these. Press the F2 key to see your input. (Press F2 to close the text screen).

NOTE: If you are using AutoCAD R14 (or earlier), your command line may look different, but the input will still be the same.

Remember to press ENTER after entering each co-ordinate point.

Command: l LINE

From point: 1,1

Specify next point or [Undo]: 4.1,1

Specify next point or [Undo]: 4.5,2.2

Specify next point or [Close/Undo]: @2.3,0

Specify next point or [Close/Undo]: @1.4<30

Specify next point or [Close/Undo]: @0,2.1

Specify next point or [Close/Undo]: @1.6<120

Specify next point or [Close/Undo]: @-1.3,0

Specify next point or [Close/Undo]: @0,-1.4

Specify next point or [Close/Undo]: @2.2<135

Specify next point or [Close/Undo]: @-1,0

Specify next point or [Close/Undo]: @1.5<225

Specify next point or [Close/Undo]: @-1,0

Specify next point or [Close/Undo]: @2.3<-60

Specify next point or [Close/Undo]: 1,1